Square TMD-Display
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
18
Alarm sounds
(a sequence of brief beeps with a higher pitch),
The alarm sequence will only stop when the alarm object gets deactivated or when the
user touches any of the buttons (this will not trigger any action, only the alarm
deactivation). Note that doorbell requests are ignored while the alarm is active.
A general parameter is provided to make the ETS parameterisation easier in case the
doorbell and alarm functions are not required and the user feels comfortable with the
default button beeps. On the other hand, customising the button, doorbell and alarm
sounds involves a set of parameters, as explained next.
ETS PARAMETERISATION
In case the default button beep sound matches the requirements of the installation and
the doorbell and alarm functions are not necessary, the “
Sounds
” parameter in the
general
Configuration
tab (see section 2.2.1) can be set to “Default”. This will also
imply that the button beeps will be unconditional, as it will not be possible to disable
this function through an object.
On the other hand, if set to “Custom”, a specific tab named “
Sounds
” will show up in
the tab tree on the left. The initial configuration of this screen is equivalent to the
aforementioned default option. However, the following parameters will be configurable.
Figure 10
General – Sounds.
Disable button sound
: enables or disables the button and action beeps. If
enabled (default option) the following parameters will also be available:
Enable / Disable button sounds through a 1-bit object
: makes it
possible to disable / resume the button beeping function in runtime by
writing to a specific object (“
[General] Sounds – Disabling button
sound
”).
