Square TMD-Display
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
17
that it was not already in this mode). The range is 0 to 65535 seconds (0 by
default).
Brightness Mode after ETS download
: sets which of the two modes
(“Normal” or “Night”) will be active after an ETS Download.
2.2.4.2
DISPLAY
Figure 9
General – LEDs & Display – Display configuration.
Display contrast level
: value to set the display contrast level, from 1 to 10 (7
by default).
Object for changing the contrast level
: enables a one-byte object
(“
[General] Display - Contrast
”) to change the display contrast level in real
time.
2.2.5
SOUNDS
Apart from the behaviour of the LEDs, it is possible to configure
the Square
TMD-
Display so that a
brief beep
is
emitted as an acoustic feedback in the following cases:
When a button is pressed
: short beep indicating that the user has pressed a
button. This only applies to step controls, i.e., controls that walk through a
certain range of values and that do not send a value after every touch, but
only the final value after the last press.
When an action has been triggered
: sharper beep than the above one,
indicating that a value is being sent to the KNX bus.
Enabling and disabling the button sounds can be done in parameters or through an
object, being also possible to define in parameters whether the button sounds should
be initially enabled or not.
On the other hand, Square TMD-Display can also emit the following sounds on request
(through the corresponding communication objects):
Doorbell
sounds
(a single beep),
