Square TMD
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
16
2.2.7
WELCOME BACK OBJECT
Square TMD can send a specific object (the
welcome back object
) to the KNX bus
when the user presses a touch button after a significant amount of time since the last
press. Sending it or not can also depend on an
additional, configurable condition
consisting in the evaluation of up to five binary objects.
Any actions that in normal operation may be executed will not be if the welcome back
object is sent to the bus. Thus, if the user presses a button and this causes that the
welcome back object is sent, the normal action of that button will not be triggered. On
the other hand, if the additional condition is not evaluated to true, the device will react
normally. Hence, the action corresponding to the button touch will be executed.
The welcome back object can consist in a
one-bit
value or a
scene
value (or both),
depending on the parameterisation.
ETS PARAMETERISATION
After enabling “
Welcome Back Object
” (see section 2.2.5), a new tab will be
incorporated into the tree on the left.
This screen contains the following parameters:
Figure 13
General - Welcome Back Object.
Timeout (since last touch)
: sets the minimum time (1 to 255 seconds, 1 to
255 minutes, or 1 to 255 hours) that should elapse after the last button touch
before the next one triggers the execution of the welcome back function.