Zenith PRO 1200, Руководство пользователя

Страница: 92 / 164

PROVERGE SETUP AND ADJUSTMENT
PV152
3-21
PRO1200 PROVERGE SETUP
After completing each test, the status report will give the
test result :
– Pass; or
– Failed plus the error number.
During the Interface Test, the following messages will be
displayed one after another on the screen:
– Ready and Config Test;
– Ready and Config OK;
– Config Ackn. Test;
– Config Ackn. OK;
– Full Config Test;
– Full Config OK;
– Interface Test OK.
In case of failures, the error message will be shown :
– FAILED... Error 01; or
– FAILED... Error 02; or
– FAILED... Error 03.
During the Generic Test, the following messages will be
displayed one after another on the screen:
– Config for Generic;
– Config for Generic OK;
– Chipselects Test;
– Chipselects OK;
– Addressability Test;
– Addressability OK;
– Crystal and Reset Test;
– Crystal and Reset OK;
– Generic Test OK.
In case of failures, the error message will be shown :
– FAILED... Error 11; or
– FAILED... Error 12; or
– FAILED... Error 13; or
– FAILED... Error 14; or
– FAILED... Error 15.
During the Sync Test, the following messages will be displayed
one after another on the screen:
– Config for Sync;
– Config for Sync OK;
– Horizontal Sync Test;
– Horizontal Sync OK;
– Vertical Sync Test;
– Vertical Sync OK;
– Frame and Field Test;
– Frame and Field OK;
– Sync Test OK.
In case of failures, the error message will be shown :
– FAILED... Error 21; or
– FAILED... Error 22; or
– FAILED... Error 23; or
– FAILED... Error 24; or
– FAILED... Error 25; or
– FAILED... Error 26; or
– Sync Test Error 27
No Syncs found
Check Camera & Cabling.
During the Ram Test, the following messages will be displayed
one after another on the screen:
– Config for Ram;
– Config for Ram OK;
– Ram Data Lines Test;
– Ram Data Lines OK;
– Ram Address Lines Test;
– Ram Address Lines OK;
– Ram Full Content Test;
– Ram Full Content OK;
– Ram Test OK.
In case of failures, the error message will be shown :
– FAILED... Error 31; or
– FAILED... Error 32; or
– FAILED... Error 33; or
– FAILED... Error 34.
If all the tests are successful, the
PROVERGE Diagnostics
menu will be as follows :
Press the <EXIT> button to return to the
PROVERGE
menu.
Refer to the Installation Adjustment Mode
section for On Screen Convergence Alignment.