AC POWER CONNECTION
PV152
1-10
PRO1200 AC POWER CONNECT
AC Power (mains) cord connection
Use the supplied cord to connect your projector to the wall
outlet. Plug the female power connector into the male
connector at the back of the projector.
This projector may be connected to an IT-power system. The
IT-power system is a power distribution system having no
direct connection to earth. Instead, the exposed conduc-
tive parts of the electrical installation are earthed.
AC Power check
Check the power voltage which is determined by the ART. NR.
(Article number) included in the label pasted on the
backside of the projector.
RS232 IN
RS232 OUT IR
REMOTE
Art. nr.xxxxxxxxx
Serial nr. xxxxxxx
Projectors with the ART. NR. R9000901 and R9000902 must
be connected to a 230 VAC power source.
If the indicated voltage is different from that of the wall outlet,
call a qualified technician for power adaptation of the projector.
AC Input power (mains) voltage adaptation
Attention !
The
ZENITH PRO 1200 - R9000908
and
R9000907
leave the
factory to operate on a mains (power) input of
120 Vac
.
Adaptation of the power input of the projector between 230
Vac and 120Vac or vice versa is possible.
Follow the procedure as described below to adapt the
voltage :
•
WARNING: turn off the projector and be sure the AC
Power Cord is unplugged before starting the procedure!
• Open the top cover (see 'Access to controls' on p.4-1).
• Unscrew the retaining screws of the AC power input board
and remove this board.
• Pull out the 'Power selector plug' (Photo 2) and reinsert
it as illustrated in Photo 3, depending on the AC power of
the wall outlet in the room.
• Pull out the fuses and place the correct fuses in their
sockets. See the table below for the correct type of fuses.
• Reinsert the power input board and secure it with the
retaining screws.
Fuses
If AC level is changed Fuse Replacement is necessary
ON
OFF
POWER / MAINS
800 peripherals
R
G
B
Comp-/H-Sync
V-Sync
COMM. PORT
P O R T 3
PORT 4/5
V-nom
I-nom
F r e q
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
S-VIDEO
OFF - ON
75 Ohm
V I D E O
green : operation
r e d : s t a n d b y
PORT 2
PORT 1
OFF - ON
75 Ohm
PROJECTOR MODE
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
d e v i c e m a y n o t c a u s e h a r m f u l i n t e r -
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation"
ON
OFF
POWER / MAINS
V-nom
I-nom
Freq
120/230 V
7/5 Amp
50/60 Hz
Power selector plug
Fuses
AC Power
input board
2
Power selector on 230V
Power selector on 120V
230V
120V
3
ART.NR.:RXXXXXXX
SER.NR.:RXXXXXXX
AC Power
Fuse
230 Vac
T6.3A/250V (2x)
120 Vac
T10A/250V (2x)
