804050NZ- CS Commercial HydroTap - Installation Instructions - 09.2016 v3.01
Page 19 of 20
OPEN Position
CLOSED Position
ON
OFF
Stop cock
operation
Commissioning
NOTE:
For any subsequent fi lter changes or any operational procedures, please refer to the HydroTap user
guide, located inside the fi lter housing access door.
Trouble Shooting
In order to help preserve our environment we ask that you dispose of this product correctly. Please contact
your local city council for collection centre details.
End of Life Disposal
System Fault
Message
Possible Cause
Solutions
Power board fault
Electrical disruption
Check power supply and all fuses
Interface fault
Internal fault
Call Zenith Service
Level board fault
Internal fault
Call Zenith Service
Condenser screen blocked Blocked Air filter
Remove blockage / Clean filter / check user guide
Water leak, Isolate mains
Water leak
Turn off mains water supply / Call for service
Compressor over-run
Compressor too Hot
Check ventilation
Water supply failed
No water
Check water supply is turned ON
Cold sensor Open
Internal fault
Call Zenith Service
Cold sensor Closed
Internal fault
Call Zenith Service
Flood sensor Open
Internal fault
Call Zenith Service
Condenser sensor Closed Internal fault
Check Ventilation / Call Zenith Service
Condenser sensor Open
Internal fault
Check ventilation / Call Zenith service
Compressor driver fault
No chilled water
Call Zenith Service
Condenser overtemp.
Blocked air filter
Remove blockage / Clean filter / check user guide
A DC Pump is faulty
Internal fault
Call Zenith Service
Comp Fuse/Driver Fault
Internal fault
Call Zenith Service
Flash Mem corrupted
Internal fault
Call Zenith Service
Flow Sensor Fault
Internal fault
Call Zenith Service
Call an electrician, a plumber, or Zenith on 0800 558055 for assistance, service, spare parts or enquiries.
