17
4.1.5
On models ASR – ASI – ASF
ASR18A / 24A
ASR36A / 48A / 60A
ASI18A / 24A
ASI36A / 48A / 60A
A - k
= Infrared receiver
B - l
= “OPERATION“ Operating status indicator
C - m = “TIMER” Timer setting indicator
D - j
= Indicator for warm start-up or defrosting “DEFROST” (heating mode)
E - n
= Indicator for unit safety mode (see self-diagnosis)
F - o
= Ind Manual start up button (override)
5. INSTRUCTION FOR USE
5.1 General instructions
To obtain the best performances in terms of comfort and regulation, the following points should be
taken into account:
Orient the air flows correctly so that they do not blow directly onto people.
Adjust the set temperature so that it is not too excessive and so that the difference
between the inside and the outside temperature is not too large (it is recommenced that
this difference does not exceed 8°C).
Close all doors and windows in order to maintain energy efficiency and avoid severe
condensation (in cooling (COOL) mode or dehumidify (DRY) mode).
During the summer months, if possible close shutters on windows to avoid direct sunlight in
the room.
Do not install objects that may obstruct the air inlet or outlets of the indoor and outdoor
units, performance could decrease considerably and the appliance could become a safety
hazard.
Clean the filters periodically otherwise efficiency may be affected.
Before long periods during which the product will not be in use, operate the product in fan
only mode for half a day to dry the internal parts then disconnect the power supply and
remove the batteries from the remote control.
When re-starting the product after a long interval, re-connect the main power supply and
wait for half a day before operating the product.
For information :
The compressor will only re-start 3 minutes after a power cut or a regulation stop (anti-
short protection cycle).
Following a power cut, the product will re-start in the operating mode it was set to before
the power cut occurred.
In heating mode, the indoor unit fan will only begin operating when the temperature of the
heat exchanger is high enough to avoid any problems of discomfort.