14
3.5.6 Programming ‘TIMER’ (R06-R05)
Clock setting
Before programming the TIMER ON and TIMER OFF, you need to set the remote controller
clock.
Press the CLOCK button for 4 seconds.
The Hour displays under CLOCK blinking on the remote controller.
Press the
button to increase, or
button to decrease, the clock from minutes till minutes
(1 pressing = 1 minute).
An extend pressing on the button
or
allows to increase or decrease the value by step
of 10 minutes.
5 seconds after depressing the button (once the desired clock has been set) the remote
controller registers the CLOCK and displays it.
Automatic start programming function
When the product is stopped, this function enables the user to programme the time at which
the product will start up
With the appliance operating, and outside the receiver range, press the ON/OFF button
twice to delete all previous programmes.
Press the TIMER button once
appears on the remote controller; the hour "6:00" blinks near the pictogram.
Then press the
button several times to increase, or
to decrease the hour before
starting (1 pressing = 10 minutes)
2 seconds after depressing a button (once the desired hour before starting has been set)
the remote controller sends the start programme command to the products.
The
message and the hour remain displayed on the remote control indicating that a start
programme is active, "TIMER" programming indicator of the indoor unit display panel is
shown.
Note
The TIMER function is only active once: once the programming function has been carried out, the product returns
to the previously programmed operating mode and the "TIMER" indicator on the indoor unit display panel
disappears.
Automatic stop programming function
When the product is operating, this function enables the user to programme the time at which
product will stop operating.
With the appliance operating, and outside the receiver range, press the ON/OFF button
twice to delete all previous programmes.
Press the TIMER button twice.
appears on the remote controller; the hour "0:00" blinks near the pictogram.
Then press the
button several times to increase, or
to decrease the hour before
starting (1 pressing = 10 minutes)
2 seconds after depressing a button (once the desired hour before stopping has been set)
the remote controller sends the start programme command to the products.
The
message and the hour remain displayed on the remote control indicating that a stop
programme is active, "TIMER" programming indicator of the indoor unit display panel is
shown.
Note
The TIMER function is only active once: once the programming function has been carried out, the product returns
to the previously programmed operating mode and the "TIMER" indicator on the indoor unit display panel
disappears.