Zelmer 28Z018, Инструкция по эксплуатации

Страница: 53 / 56

53
Control light goes of – f when the required temperature is reached. The
iron is now ready for use.
Move the Steam –
Control Knob (2)
to se -
lected position, in order to set the amount
of steam.
After finishing move the – Temperature Dial
(11) in anti-clockwise direction to „ MIN ”; the
iron is switched off.
Move the – Steam Control Knob (2) to
position.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
Burst of steam
– Always follow the garment manufacturer’s
ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove stubborn wrinkles
at clothes and hanging garments.
Fill the water tank with demineralised water or distilled water. (See –
“How To Fill Water”).
Move the –
Steam Control Knob (2)
to position.
Turn the – Temperature Dial (11) in clockwise direction to ●●●.
Connect the iron to a suitable mains supply outlet. See „Preparation –
for operation”.
Control light (12) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Press the – Burst of Steam Button (4) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds –
before pressing the Burst of Steam But -
ton (9) again. Most wrinkles can be re -
moved within three presses.
After finishing move the – Temperature Dial
(11) in anti-clockwise direction to „ MIN ”; the
iron is switched off.
Move the – Steam Control Knob (7) to
position.
Disconnec – t the iron from mains supply outlet.
When the iron gets cool completely, store it vertically in a safe place. –
ATTENTION:
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the Burst Of Steam more
than three times after the pilot light goes off.
Burst of steam in vertical position
– Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on deli -
cate garments in hanging position, hanging curtains, or other hanging fab -
rics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Temperature of steam is very high.
Fill the water tank with demineralised water, or distilled water. (See –
How To Fill Water)”.
Move the – Steam Control Knob (2) to position.
Turn the – Temperature Dial (11) in clockwise direction to ●●●.
Connect the iron to a suitable mains supply outlet. See „Preparation –
for operation”.
Control light (12) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Hold the iron between 15 and 30 centimetres away from the garment. –
Press the – Burst of Steam Button (4) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds –
before pressing the Burst of Steam But -
ton (4)
again. Most wrinkles can be re -
moved within three presses.
After finishing move the – Temperature Dial
(11) in anti-clockwise direction to „ MIN ”; the
iron is switched off.
Mov
–
e the Steam Control Knob (2)
to
position.