Zeiss CenterMax, Руководство по эксплуатации

Страница: 87 / 166

Switching the CMM on
6-7
CenterMax Operating Instructions 61211-1020202
Switching the drives on
• Turn the rotary switch (4) clockwise approx. 90° and hold it there
until the indicator lamp above it lights up.
As soon as the indicator lamp above the switch lights up, the
drives are switched on. The rotary switch does not engage. snaps
back to its home position as soon as it is released.
Selecting the operating mode
It is also possible to set the operating mode later.
• Turn the key-operated switch (6) to the required position.
MAN : Manual mode – Set-up mode. The travel speed is limited in
all three axes.
You must set this operating mode for …:
– Joystick-controlled probing
– Programming CNC runs
– Testing CNC programs.
AUTO : Automatic mode – series measurement mode. Travel at
maximum speed in all axes.
You must set this operating mode for …:
– Workpiece measurement by means of a CNC program.
Danger!
When starting a CNC program, make sure that no one is in the dan-
ger area of the CMM. The operating mode setting (MAN or AUTO) is
irrelevant.
• Check to make sure that no one is in the danger area of the CMM.
Important!
The AUTO mode may only be set if the CNC program was tested in
the manual mode beforehand. This prevents collisions at high travel
speeds in the automatic mode.
When starting a CNC program, the key should be removed and stored
in a safe place to prevent the setting from being changed accidentally.
Switching the computer on
• Switch the computer on and other peripheral devices, e.g. the
printer.
• Boot the computer; start the operating system.
• Start the measuring software.
!
!
NOTE