PUTTING THE INSTRUMENT INTO OPERATION
Axio Vert.A1
Mounting Optional Components
Carl Zeiss
05/2012
431030-7044-001
65
If the installation of filters not provided with
direction markings (arrows) proves necessary, we
recommend that the procedure below be followed:
Be sure to install filters with reflecting, dielectric
layers in such a way that the reflecting layer
(Fig. 3-29/
6
) in the excitation filter (Fig. 3-29/
5
)
points outward (in relation to the reflector
module). In the barrier filter (Fig. 3-29/
1
), the
reflecting layer(Fig. 3-29/
2
) must point inward
(Fig. 3-29).
In mounting position, the reflecting layer
(Fig. 3-29/
4
) of the beam splitter (Fig. 3-29/
3
) must
point downward.
The arrows (Fig. 3-29/
7
) mark the illumination
beam path or the imaging beam path.
3.3.4
Changing the Beam Splitter in the FL P&C Reflector Module
Please, proceed with utmost care in mounting the filters and the beam splitter to avoid
damaging and soiling optical components.
We recommend that you order fully fitted FL P&C
reflector modules from Carl Zeiss, as changing the
beam splitter is a demanding operation.
Proceed as follows when changing the beam
splitter:
•
Remove the FL P&C reflector module from the
reflector turret. (See also Section 3.1.9.)
•
Loosen the two slotted screws (Fig. 3-30/
1
) with
a screwdriver.
•
Hold the two reflector module halves -
emission
module half (Fig. 3-30/
2
)
and
excitation
module half (Fig. 3-30/
3
) together,
turn them over against the mounting position
and set them down.
Fig. 3-29
Installing Filters and Beam Splitters
Fig. 3-30
Opening the Reflector Module
Содержание Axio Vert.A1
Страница 1: ...Operating Manual Axio Vert A1 Inverted Microscope ...
Страница 106: ......
