Zehnder Rittling ComfoAir 350, Руководство по установке

Страница: 18 / 36

EN - 18
The default settings of the ComfoAir nL are:
Position l
ow
35%
Position m
edium
50%
Position h
igh
70%
The default settings of the ComfoAir HL are:
Position l
ow
40%
Position m
edium
70%
Position h
igh
90%
Follow this procedure to programme the ComfoAir
(after installation):
1. Set the ComfoAir in programming mode.
- Display: Press simultaneously for at least 3
seconds on " " and " " until “InR” appears
on the display.
In programming mode, the bypass and
Preheater element valves are always closed.
After 30 minutes, the ComfoAir automatically
terminates the programming mode.
2. Close all windows and outside doors.
3. Close all inside doors.
4.
Check the presence of structural overflow
provisions.
The structural overflow provisions must be at
least 12 cm2 per l/s.
5. Check if both fans function in the three speed
settings.
6. Switch the ComfoAir to high speed.
7. Install all valves and set the valves according
to the settings given or as set in the reference
house.
If no data are known:
– Install the valves and
open
them as far as
possible.
– Measure the air volumes; starting with the
intake air and then the exhaust air.
– If the measured air volumes deviate from the
nominal air volumes by more than +/-10%,
and the majority of the deviations is positive,
ensure that all deviations are positive. If the
majority of all deviations is negative,
ensure
that all deviations are negative. Ensure that
one supply valve and one exhaust continue to
be fully open.
8. Change the fan settings in P menus P30 to P37 of the
digital operating device.
– Select the lowest possible setting in order to
conserve energy.
– Ensure that the ratios between low, medium and
high remain equal.
Use the chart of the ComfoAir's air
specifications to set the fans.
9. In the event that the currently set air volumes still
deviate too much: Adjust the valves.
10. Check the entire installation again, after all
valves have been set.
11. Switch the ComfoAir (back) to ventilation
position 2.
2.8 Programming air specifications
After installation, the ComfoAir must be programmed.
This can be done using the air specifications of the ComfoAir above.