10
1
2
6
3
4
5
Illustration “A”
Non-Slip Plate
(Standard System Only)
(Single Cylinder Band Assembly)
Fitting and Assembly
Illustration “B”
Threading The Standard
Single Cylinder System
1. Thread cylinder band through non-slip plate and then under the bottom center backplate
straps as shown in Illustration “A.”
2. Thread cylinder band under the top center backplate strap on BC.
3. After threading bands through BC begin threading bands through bottom of buckle as per
Illustration “B”.
4. Threading it through the center slot.
5. Thread through slot closest to metal bail, pull to tighten around cylinder.
6. Loop webbing through final slot in buckle. Check to be sure that your cylinder is lined vertically
on the BC. “Cam” the buckle over for extra tension, and lock buckle by engaging touch
fastener material on cylinder strap.
