Operation manual of ZBL-R800, ZBL-R630, ZBL-C310A
Hotline: (86)010-51290405 Fax: (86)010-51290406
44
instrument reset operation is completed, and then you can pre-scan
(see instruction in 3.4.2.3), you can also press
【
SAVE
】
key to enter
into test(a square cursor will occur in the top left corner), while testing,
moving sensor in an uniformed speed, when sensor is getting closer to
rebar, scroll bars lengthen gradually, the current thickness value
decreases. When sensor goes over rebar, peep alarming, the tested
rebar will be displayed in coordinate (shown in pachytene in
figure3-30).Thickness value of cover and coordinates of tested rebar
will be displayed in the upper side of rebar and the tested result will be
stored simultaneously.
When the moving distance is more than 1.2m and goes over the range
of each screen, it will turn pages automatically, the amount of whole
pages in the top left corner will increase by one.
After the test is completed, pressing
【
BACK
】
key to store testing data
and go back to parameter setting interface in figure 3-28 for parameter
resetting , and test again, or pressing
【
MENU
】
to go back to main
menu.
Illustration:
1.
Retesting, excessive display of profile scanning is same with
grid scanning for definition and operation.
2.
User can select range and method of measurement in profile
scanning, see 3.4.1.1 for definition and operation.
3.
Each screen of profile scanning can show 1.2m, while in grid
scanning, it is 1.0m.
3.4.4 Data display
It is mainly used for displaying of stored objects and their data and
images.
In the main menu as shown in figure3-6, pressing
【
a
】
or
【
b
】
to
shift
to the front of “Data Display”, then pressing
【
ENTER
】
to
