Operation manual of ZBL-R800, ZBL-R630, ZBL-C310A
Hotline: (86)010-51290405 Fax: (86)010-51290406
22
3.4.1 General-scan
General-scan is the basic testing function of rebar test. The thickness
of rebar cover and the diameter of rebar can be measured precisely
with this function.
After connecting the host and sensor with signal wire, press
【
a
】
and
【
b
】
to shift to General-scan and press
【
ENTER
】
to enter into
the parameter setting interface (as shown in figure 3-7) of general scan,
and cursor will stay in the position Obj. No.
Attention: when entering into parameter setting interface,
quantity of electricity will be tested. When it is too low, tip of “lack
of electricity, please charge” will be presented on the middle of
interface and vocal warning requires immediate charging, at that
time, users should not continue parameter setting or tests, or
data is easy to lost or make error. It is better to exit from testing
interface and go back to main menu, then shutdown, finally
change battery or charge.
3.4.1.1 Parameter setting
After entering interface in figure 3-7, pressing
【
a
】
,
【
b
】
to select
the parameter to be set, and
【
ENTER
】
for starting to set
corresponding parameter. After all done, select Start Scan to enter
testing interface or press
【
MENU
】
to go back to the main menu.
Figure3-7 Parameter setting
