Main Menu ENG Setup Menu
18
Sample Rate Select
This is where the sample rate is set.
Please note when recording sample rates of 48048 or higher there is a
limitation of 8 tracks or less. The sample rate select menu has a matrix that allows for record tracks to be
enabled or disabled.
Prerecord
From the point the Nova is powered up, all inputted audio is being processed. When prerecord is enabled,
up to 10 seconds of that processed audio is held in a prerecord buffer. Then when the record key is pressed
that stored audio, with its time code, is included the current take. Prerecord does not use any additional
battery power.
Please note the prerecord buffer is dumped after any of the following settings are changed: sample-rate,
time code frame rate, user-bits, or record enables. After these parameters are changed the buffer will start
to re-build.
Also note that prerecord is only available when the sample is set to 48048 or lower.
TC Transport
•
NORMAL
- Nova will go into record when the REC key is pushed.
•
AUTO LOAD
- Nova will automatically go into to record when it senses record run time code coming from
an external source. Please note to use Auto-Load, time code needs to be set to record run both from the
incoming source as well as in Nova.
LCD Brightness
This is where the brightness of the LCD screen is adjusted from. The screen brightness can be set from 1 to
11 with 11 being the brightest.
LED Brightness
This is where the brightness of the LEDs are adjusted from. Please note this is a global setting, meaning that
all LEDs will be set to the same brightness. The LED brightness can be set from 0 to 11 with 0 being off and
11 being the brightest setting.
Slate Microphone Source
INTERNAL
- The slate microphone located on the front panel of Nova will be used for the slate and com.
EXTERNAL
- An external slate microphone connected to the 3.5mm microphone input connector on the side
of Nova will be used for the slate and com.
Multi-Trim
When turned on the Multi-Trim allows multiple inputs to be controlled with a single fader.
When a fader has multiple inputs assigned to it instead of a single LED a group of 3 LEDs will illuminate as
the pointer.
The fader will be assigned its inputs from the fader assign matrix.
Play to Outputs
Play to outputs allows Nova to play the record track to its output busses.
