AEXZP0BB - ECO SMART DISPLAY - User Manual
Page - 23/43
-
OPTION #1: the traction hourcounter is displayed
-
OPTION #2: the machine hourcounter managed by the display is
displayed
MENU ADJUSTMENTS
1) SPEED
FACTOR
It adjusts speed coefficient to have the correct truck speed value shown on
the display. This coefficient has to be regulated depending on truck mechanic
characteristics. It is the result of following formula:
Speed Factor = (88 * rr * p) / Ø
Where:
rr = total gearbox reduction ratio
p = number of pair pole of the motor
Ø = traction wheel diameter expressed in centimeters (cm)
7.5 Special Adjustment menu
To enter this Zapi hidden menu a special procedure is required. Ask this
procedure directly to a Zapi technician.
Following parameter can be configured in this menu:
1) CHECK
UP
DONE
It can be ON/OFF. If it is ON it is possible to reset the last maintenance hour-
counter, the “SERVICE REQUIRED” alarm and possible reductions.
2) RESET HOURMETER
It can be ON/OFF. If it is ON it is possible to reset the machine hour-counter
(managed by display – HOUR COUNTER set to OPTION #2).
7.6 Parameter change menu
Following parameters can be configured in this menu:
1) CHECK
UP
TYPE
It defines the truck behaviour when a maintenance is required.
-
LEVEL 0: the “SERVICE REQUIRED” alarm doesn’t appear
-
LEVEL 1: the “SERVICE REQUIRED” alarm appears after a time equal
to the hours set in the CHECK UP HOURS parameter
-
LEVEL 2: the “SERVICE REQUIRED” alarm appears after a time equal
to the hours set in the CHECK UP HOURS parameter and
after 50 additional hours the truck speed is reduced
2) CHECK
UP
HOURS
It defines the hours after which a maintenance is required. It can be adjusted
in the 100 to 1000 hours. The resolution is 100 hours (it can be adjusted in
steps of 100 hours).
