Zapi COMBIACX, Руководство пользователя

Страница: 73 / 81

AFCZP0BC – COMBIACX & ACEX - User Manual Page - 73/81
Error code Description Effect
Machine status
when the test is
done
Restart
procedure
Drv. Shor. EV1 dri -
MDI CAN 74 EV1 on/off valve drivers shorted
(always ON) On/off valves stopped start-up, stby valve on/off request
Drv. Shor. EV2 -
MDI CAN 74 EV2 on/off valve driver shorted
(always ON) On/off valves stopped start-up, stby valve on/off request
Drv. Shor. EV3 -
MDI CAN 74 EV3 on/off valve driver shorted
(always ON) On/off valves stopped start-up, stby valve on/off request
Pump I NO zero -
MDI CAN 56 Pump chopper current sensor
feedback is out of permitted stby
range Pump motor stopped start-up, stby pump request
Pump I=0 ever -
MDI CAN 52 Pump current feedback is always
0A even when pump motor is
running Pump motor stopped pump function pump request
Cont. Drv. Ev1 - MDI
CAN 75 Driver of Ev1 is open, not able to
close Ev1 stopped during Ev1
function valve Ev1 request
Cont. Drv. Ev2 - MDI
CAN 75 Driver of Ev2 is open, not able to
close Ev2 stopped during Ev2
function valve Ev2 request
Cont. Drv. Ev3 - MDI
CAN 75 Driver of Ev3 is open, not able to
close Ev3 stopped during Ev3
function valve Ev3 request
Pump Vacc not OK -
MDI CAN 89 The pump accelerator value is
higher than the minimum value
recorded, and the lift/lower
switches are open Pump stopped Continuous Pump request
Sens. Mot. Temp.
KO - MDI CAN 67 The motor temperature sensor is
damaged Performance highly
reduced Continuous Key-on recycle
Vacc out range -
MDI CAN 85 The voltage on CNC#4 is out of the
parameters range Traction stopped Continuous Program VACC
Stall rotor - MDI
CAN 11 The traction rotor is stuck or the
encoder is not working Traction stopped Continuous Key-on recycle
EVP driver open -
MDI CAN 48 The EVP driver isdamaged or the
EVP coil impedance is too low EVP stopped Continuous Key-on recycle
Many pump reqs -
MDI CAN 49 There are too many pump requests
at the same time Pump stopped Continuous Remove request
Pump inc start - MDI
CAN 79 Incorrect pump starting sequence Pump stopped start-up, stand-
by Pump request
Pump Vacc range -
MDI CAN 90 The voltage on CNC#9 is out of the
parameters range Pump stopped, EVP
stopped Continuous Pump request
Param. Restore -
MDI CAN 13 A parameters set restore was
made since the last keyoff No effect start-up Traction, pump or
EVP request
Wait mot. P. still -
MDI CAN 63 The software waits for the motor
pump to stop Valve, pump, traction
stopped, LC opened,
Eb applied start-up None