Zapi COMBIACX, Руководство пользователя

Страница: 45 / 81

AFCZP0BC – COMBIACX & ACEX - User Manual Page - 45/81
speed applied when the Hard & Soft function, CNC#7 connector, is active.
When set to 100% the speed reduction is ineffective.
15) EPS STEER CUTBCK
Tipically from 1% to 100%. It determines the percentage of the maximum speed
when the wheel is completely turned (tipiccally 90 degrees).
If the wheel angle is a percentage of the maximum angle, the steer cutback is
applied proportionally.
4
Note: the wheel angle is coming from EPS. If EPS option is set to NONE, this
parameter is useless.
16) FREQUENCY CREEP
Hz value. This is the minimum speed applied when the forward or reverse
switch is closed, but the accelerator is at its minimum.
17) MAXIMUM CURRENT
Maximum level of the current (percentage of the maximum current of the
controller).
18) ACCELERATION SMOOTH
It gives a parabolic form to the acceleration ramp.
19) INVERSION SMOOTH
It gives a parabolic form to the acceleration ramp after a direction inversion.
20) STOP SMOOTH
Hz. It sets the level of frequency where the smooth effect of the acceleration
parabolic form ends.
21) BRK SMOOTH
It gives a parabolic form to the deceleration ramp.
22) STOP BRK SMOOTH
Hz. It sets the level of frequency where the smooth effect of the deceleration
parabolic form ends.
23) AUXILIARY TIME
Time units value (seconds). For the encoder version, it determines the time
duration the truck is hold on the ramp if the STOP ON RAMP option is ON.
24) HYDRO TIME
Sec. It determines the time duration the pump motor is driven after the hydraulic
request is released.
25) PUMP IMAX
Level 0 to 9. Set the maximum current for the pump motor.
26) PUMP ACCELERATION DELAY
In seconds. Set the acceleration ramp for the pump motor.