5
90°
6
2
1
7
Open the door fully and hold the two door hinges.
1
Lift and turn the levers on the two hinges.
2
Close the oven door halfway to the first opening position. Then pull forward and remove the door from
its seat.
3
Put the door on a soft cloth on a stable surface.
4
Release the locking system to remove the glass panels.
5
Turn the two fasteners by 90° and remove them from their seats.
6
First lift carefully and then remove the glass panels one by one. Start from the top panel.
7
Clean the glass panels with water and soap. Dry
the glass panels carefully.
When the cleaning is completed, install the glass
panels and the oven door. Do the above steps in
the opposite sequence.
Make sure that you put the glass panels (A and B)
back in the correct sequence. The middle panel (B)
has a decorative frame. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
frame (B) on the screen-printing zones is not rough
when you touch it.
A
B
Make sure that you install the middle panel of glass
in the seats correctly.
REPLACING THE LAMP
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
22
Downloaded from www.vandenborre.be