Do not start the Pyrolysis if you did not
fully close the oven door. In some
models, the display shows "C3" when
this error occurs.
WARNING! The appliance becomes
very hot. There is a risk of burns.
CAUTION! If there are other
appliances installed in the same
cabinet, do not use them when the
Pyrolysis function operates. It can
cause damage to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot water,
so that the residues do not burn from the hot
air.
3. Set the Pyrolysis function. Refer to "Oven
functions".
4. When
flashes, press or to set the
necessary procedure:
Option
Description
P1
If the oven is not
very dirty. Time of
the procedure: 1 h.
P2
If you cannot easily
remove the dirt.
Time of the proce-
dure: 1 h 30 min.
Press or turn the knob for the temperature to
start the procedure.
You can use the End function to delay the start of
the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. When the oven is at its set temperature, the
door locks. The display shows the symbol
and the bars of the heat indicator until the door
unlocks.
To stop Pyrolysis before it is completed, turn
the knob for the oven functions to the off
position.
6. When Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked.
7. When the appliance is cool again, an acoustic
signal sounds and the door unlocks.
CLEANING REMINDER
To remind you that the Pyrolysis is necessary, PYR
flashes in the display for 10 seconds after each
activation and deactivation of the appliance.
The cleaning reminder goes out:
• after the end of the Pyrolysis
function.
• if you press and at the same
time while PYR flashes in the
display.
CLEANING THE OVEN DOOR
The oven door has three glass panels.You can
remove the oven door and the internal glass panels
to clean them.
The oven door can close if you try to
remove the glass panels before you
remove the oven door.
CAUTION! Do not use the appliance
without the glass panels.
1
2
3
4
21
Downloaded from www.vandenborre.be