Upper axis limit switch magnets
Lower axis limit switch magnets
To adjust the limits, loosen the screws by about 1/2 turn, slide the screw to the desired location and re-tighten.
Make sure that the green hall sensor PCB (visible through the magnet adjustment slots) always stays in between
the limit screws.
When adjusting the limit switch magnets, ensure that the green sensor PCB remains in between two magnets.
Software
In addition to the regular software options available for all Zaber devices, the ASR-E is supported by Micro-Manager
open source microscopy software. Micro-manager can be downloaded for free from the
Micro-Manager website
.
Warranty and Repair
For Zaber's policies on warranty and repair, please refer to the
Ordering Policies
.
Standard products
Standard products are any part numbers that do not contain the suffix ENG followed by a 4 digit number. Most, but
not all, standard products are listed for sale on our website. All standard Zaber products are backed by a one-month
