5. Repeat the same procedure for the lower-axis shipping plate.
Move the lower-axis to gain access to the 4 screws holding the
lower-axis shipping plate to the underside of the mid-plate.
When all 4 screws are removed, remove the plate. The stage is
now ready to be installed and used.
Mounting
The ASR050B050B-E and ASR100B120B-E stages are mounted using adaptor plates. The ASR205B205B-E and
ASR305B305B-E mount directly to compatible microscopes and use adaptor plates only for breadboard mounting.
The following adaptor plates are currently available:
ASR100B120B-E
ASR050B050B-E
ASR205B205B-E /
ASR305B305B-E
AP110 - for mounting to standard
M6 or 1/4"-20 breadboards.
AP137 - for mounting to standard
M6 or 1/4"-20 breadboards.
AP160 - for mounting to standard
M6 or 1/4"-20 breadboards.
AP111 - for mounting to Leica,
Zeiss and Olympus microscopes.
AP114 - for mounting to Nikon
inverted microscopes.
AP125 - for mounting to Olympus
BX upright microscopes.
AP131 - for mounting to Olympus
IX inverted microscopes.
For more details about these adaptor plates, please see our
accessory page
.
The adaptor plates are attached to the ASR-E using 2 or 3 M3 screws per plate. To install the adaptors, align them
as shown in the pictures below and tighten the M3 screws. The stage will need to be plugged into the controller so
that you are able to move the lower axis and gain access to the screw holes.
Instructions
ASR100B120B-E
1. Position the lower axis such that you have access to the
adaptor plate mounting screw holes.
2. Place an adaptor plate underneath the ASR base.
