YOKOGAWA NEW GREEN SERIES, Руководство пользователя

Страница: 50 / 98

3-8
<Toc> <3. Operations>
IM 05D01C12-41E 4th Edition: May 31, 2006-00
5.
Press the
S E T / E N T
key once to register the
setpoint.
P V
AL1 2 3 4
M A N
R E M
S E T / E N T
A / M
6.
Press the
S E T / E N T
key for more than 3 sec-
onds. This returns you to the display
shown at power-on (figure below).
PV
AL1 2 3 4
M A N
R E M
S E T / E N T
A / M
Displays PV. Displays
target setpoint-2
“2.SP”.
3.7 Switching between Run and Stop
The following operation describes the procedure of switching from the run state (RUN) to
stop state (STOP).
NOTE
Factory-shipped setting does not allow switching between RUN and STOP by keystroke.
To perform switching by keystroke, configure setup parameter “DIS = 0.”
When the controller is stopped, input and outputs are as follows:
PV input Displays PV.
Control output Preset output value (factory-shipped setting: 0%)
Alarm output ON in the event of an alarm
1.
Bring the operating display into view
(display appears at power on).
P V
AL1 2 3 4
M A N
R E M
S E T / E N T
A / M
Displays PV. Displays
target setpoint-1
“1.SP”.
2.
Press the S E T / E N T key for more than 3 sec-
onds to call up the menu “OP.PA”.
P V
AL1 2 3 4
M A N
R E M
S E T / E N T
A / M
Displays
menu “OP.PA”.
Displays
symbol “D-U”.
3.
Press the
S E T / E N T
key several times to
display the parameter “S/R”.
AL1 2 3 4
M A N
R E M
S E T / E N T
A / M
P V
Displays
parameter
“S/R”.
4.
Press the key to display “STOP”.
SET/ENT
A/M
PV
AL1 2 3 4
REM
CAS
MAN
LP2
P V
AL1 2 3 4
M A N
R E M
S E T / E N T
A / M
Displays
“STOP”.
Blinks during
change.