How to restore default settings of a transmitter pushbutton
Default setting = clear button connections, go back to mode 1 (toggle), go back to direct mode.
1- Press any pushbutton on the transmitter
10
times (Configuration Menu).
The transmitter LED will flash rapidly.
2- While the LED is flashing, press the button on which to restore default settings
15
times.
3- The LED will flash 5 times at the end of the
15
presses.
How to restore completely default settings of a transmitter
1- Press any pushbutton on the transmitter
10
times (Configuration Menu).
The transmitter LED will flash rapidly.
2- Press one of the pushbuttons
25
times while the LED is flashing.
3- The LED will flash at the end of the
25
presses to confirm that default settings have been restored.
Go to the Configuration Menu to configure a transmitter.
To do this, press any transmitter pushbutton or a pushbutton wired to the E2BP/E2BPP/E4BPP
10
times:
the transmitter LED will start flashing rapidly.
Press the pushbutton to be configured the required number of times while the LED is flashing.
Number of presses
Possible settings
Pushbutton operating mode
1
On/Off or Up/Stop/Down
2
Memory recall or intermediate position
3
On or Up/Stop
4
Off or Down/Stop
radio mode
5
Direct mode
6
Radio bus mode
33
Using the E2BP(P)(X) / E4BPP(X) transmitters [V5(*) or later] with a normally closed contact
(NC button, automations, sensors, etc)"
Product on radio bus
10
Lights (
default configuration
)
11
Window shutters
20
Lights and window shutters [V5(*) or later]
Copy or clear connections of a pushbutton or of the entire transmitter
12
Prepare to copy to a destination pushbutton
13
Copy a source pushbutton
14
Completely duplicate the transmitter
15
Restore default settings of a pushbutton
24
Reset access points: delete all radio bus access points
25
Restore transmitter default configuration
Special functions available with Mtr2000er only
16
MTR2000ER contact pulse mode. The receiver generates a 0.5 seconds pulse
17
MTR2000ER contact relay mode. The receiver follows the operation of the transmitter pushbutton
19
MTR2000ER flashing mode: sending of a flash control (0.5 second period for 30 seconds)
For more information on how to create and configure a radio bus using Yokis radio
transmitters and receivers, scan the Qr code or go directly to www.yokis.com
Urmet S.p.a. – 10154 toriNo (itaLY) – Via Bologna 188/C
For technical information, go to www.yokis.com or call:
Customer Service: +39 011.23.39.810 - export dept. Phone: +39 011.24.00.250/256 - Fax: +39 011.24.00.296
WARRANTY:
In addition to the warranty required by law, this product is
guaranteed for 5 years
from date of manufacture. The mate-
rial must be used according to the instructions provided and for its intended use. Faults must not be caused by deterioration or acci-
dents resulting from negligence, anomalous use or incorrect installation. In all cases, the warranty only includes replacement of faulty
products. No compensation for loss or damage may be claimed
DS1054-009F
P11
T R A N S M I T T E R C O N F I G U R AT I O N S U M M A R Y TA B L E
(*) The transmitter version is printed on its back.
