YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
46
CLEANING THE AIR FILTERS (RECOMMENDED ONCE EVERY THREE MONTHS)
Note:
If the unit is in a dusty area, the air filters should be cleaned more often. After taking off the filter, be sure not to
touch the fins on the indoor unit as this can cause injury.
To Remove the Air Filter
By holding onto the bottom slot of the air filter slightly push the filter in an upward motion at a slight angle and then pull
downward carefully.
Cleaning
To clean the dust adhering to the filters, you can either use a vacuum cleaner, or wash them with warm water and a
neutral detergent, the water should be below 113°F. When the filters have been cleaned, air dry completely out of direct
sunlight.
NOTE:
Never use water hotter than 113°F to wash the unit or the filters as this can discolor and/or deform the unit. Never
dry the filters by a fire or open flame as this can be dangerous. Always air dry the filters.
Reinsert the filters
Reinsert the filters aligning with the arrow head, then cover the surface panel and clasp it.
CHECK BEFORE COOLING/HEATING SEASON COMES:
1.
If the unit is still connected to the correct electric power V/Ph/Hz.
2.
If the unit is still securely fastened.
3.
If the batteries of remote controller are good.
4.
If the filter is loaded and clean
5.
If the intake and discharge vents are clear from any obstructions.
IF THE SYSTEM IS GOING TO BE UNUSED FOR A PROLONGED PERIOD
1. Turn main power off by disconnecting electrical power disconnect switch.
2. Clean filter and unit.
3. Cover the unit to keep dust or moisture out of the unit.
