YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
44
Press "Healthy" 4 times within 3 seconds
Remote will beep 2 times, indicating it is ready to display Wattage
Display
Meaning
Display
Meaning
1
for 1 second
3
for 1 second
8.8
for 2 seconds
AC KW
9.8
for 2 seconds
DC KW
2
for 1 second
4
for 1 second
12.8
for 2 seconds
AC KW.H
3.8
for 2 seconds
DC KW.H
Note:
If no operation on remote for 10 minutes, wattage display will quit.
Operation Guide
1.
After turning on the power at the fuse box, press "ON/OFF" button on remote control to turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3.
Press " " or "
" button to set your required temperature. (Temperature can’t be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
5.
Press "SWING" button to select fan blowing angle.
Switch between °F and °C
To switch remote control and Indoor Unit between
Celsius and Fahrenheit, remove the battery cover, and
the batteries. Two switches are located behind the
battery cover. Flip the switches found on the back to the
desired temperature setting (°F or °C). Replace the
batteries. Remote will turn on in the set mode.
CHANGING BATTERIES AND NOTICES
1) Press gently along the arrowhead direction to push the back cover
open on the remote control.
2) Take out the old batteries. (As shown in figure)
3) Insert two new AAA1.5V dry batteries, and pay attention to the
polarity. (As shown in figure)
4) Attach the back cover of wireless remote control.
(As shown in figure)
NOTICES:
When operating, point the remote control transmitter at the receiving
window on indoor unit.
The distance between signal sender and receiving window should be no more than 25 ft., with no obstacles
between them.
Signal may experience interference in a room with fluorescent lamps or wireless telephones. Remote controller
should be near the indoor unit during operation.
Replace new batteries of the same type when replacement is required.
When you will not be using the remote for prolonged periods remove the batteries.
If the display on remote controller is fuzzy or there’s no display, please replace batteries.
NOTE:
When changing the batteries, do not use old or different batteries. It can cause the remote control to malfunction. The operation should
be in its receiving range. It should be placed 36 inches away from a TV set or stereo. If the wireless remote control cannot operate
normally, please take the batteries out, wait 30 seconds and reinsert them. If the remote still doesn’t operate normally, please change
the batteries. If the wireless remote control will not be used for an extended period, it is recommended to remove the batteries. Leaving
the batteries in could cause them to leak. This will cause damage to the remote control.
