YMGI VRFI-07EL-D2B(55)5, Руководство пользователя

Страница: 26 / 36

26

Setting up and down SWING:
1. Under simple SWING status, press button to adjust up and down SWING status;
2. Under fixed-angle SWING status, press
button to adjust up and down SWING angle
circularly as below:
Note: Operate continuously left and right SWING in 2 seconds, swing states will change accordingly to above-
mentioned order, or switch closed state and state;
5. Setting TURBO function:
Under cool or heat mode, press TURBO button to set TURBO function.
When
is displayed, TURBO function is on.
When is not displayed, TURBO function is off.
When TURBO function is on, the unit operates in super high speed to achieve rapid cooling or heating. When
TURBO function is off, the unit operates in normal fan speed setting.
6. Setting LIGHT function:
The LIGHT on the receiver light board will display present operating status. If you want to turn off the LIGHT,
press the LIGHT button. Press this button again to turn on the LIGHT.
7. Viewing Ambient Temperature:
In unit on status, the receiver light board or wired controller is defaulted to display the setting temperature.
Press TEMP button to view indoor or outdoor ambient temperature.
When is displayed, it means the displayed temperature is setting temperature.
When is displayed, it means the displayed temperature is indoor ambient temperature.
When is displayed, it means the displayed temperature is outdoor ambient temperature.
Note: S etting temperature is always displayed on Remote Controller.
8. Setting X-FAN function:
In cool or dry mode, press X-FAN button to set X-FAN function.
When
is displayed, X-FAN function is on.
When is not displayed, X-FAN function is off.
When X-FAN function is on, the water on the evaporator will be blown away until the unit is turned off to avoid
mildew.
9. Setting health function:
In unit on status, press button to set the health function.
When is displayed, health function is on.
When is not displayed, health function is off.
Health function is available when the unit is equipped with an ION generator. When health function is on, the
ION generator will start operation, adsorbing dusts and killing the bacteria in the room.
10. Setting air function:
Press button until is displayed, then the air function is turned on.
Press button until is disappeared, then the air function is turned off.
When the indoor unit is connected with a fresh air valve, air function setting can control the connection of fresh
air valve, which can control the fresh air volume and improve the air quality inside the room.