YMGI VRFI-07EL-D2B(55)5, Руководство пользователя

Страница: 22 / 36

22
Install the drainage pipe
(1). For correct draining, the drain hose should be slanted downward.
(2). Do not wrench or bend the drain hose or place the open end into water.
(3). Wrap with heat resistant material when connecting the longer drainage tube though to the indoor unit.
Install the Refrigeration Pipes
Connect the refrigeration pipes with the two relative leading pipes, tighten the nut on the refrigeration pipes
securely.

Be careful when bending the connecting pipes and avoid creating flats and wrinkles within the bend radius as
this will damage the pipes.

Do not over tighten/torque the flare nut. Over tighten/torqueing can cause the flare nut to leak.
Component Identification
1. Titanium Apatite Photocatalytic Air-Purifying
Filter:
These filters are attached to the inside of the unit.
2. Air outlet
3. Display
4. Front panel
5. Louvers (vertical blades)
These louvers are inside of the air outlet.
6. Air inlet
7. Air filter
8. Flap (horizontal blade)
9. Cool mode lamp
10. Heat mode lamp
11. Dry mode lamp
12. Run lamp
13. LED display
14. Indoor Unit ON/OFF switch:

Push this switch once to start operation.

Push once again to stop it.

The operation mode refers to the following
table.
Model Mode Temperature setting Air flow rate
HEAT PUMP AUTO 26
°C(78.8°F)
AUTO