YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
35
Wash the air filters with water or clean them with vacuum cleaner
If the dust does not come off easily, wash them with a neutral detergent and lukewarm water, then allow
the filter to air dry thoroughly in a place not exposed to direct sunlight. II. It is recommended to clean the
air filter every week.
Titanium Apatite Photocatalytic Air-Purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying Filter can be reused several times before requiring replacement. By
washing it with water once every 6 months, you can improve indoor air quality. YMGI recommends replacing the filter
once every 3 years.
Vacuum off dust, and soak in warm water for about 10 to 15 minutes if the filter is very dirty.
Do not remove filter from frame when washing with water.
After washing, shake off remaining water and allow it to dry in a place where it is not exposed to direct sunlight.
The filter material is made of paper. Do NOT wring out the filter after washing or soaking.
Filter Replacement
When disposing of the old filter, treat as flammable waste.
Issues caused by dirty filters.
Cannot deodorize the air effectively.
Cannot effectively remove dust or debris from the air.
Results in poor heating or cooling.
May cause odor.
Additional Maintenance
If water ever drains from the Indoor Unit, the drain hose may be damaged, blocked, or installed improperly.
Stop unit operation and contact a qualified service technician.
Check that the base/stand and other fittings of the outdoor unit are not corroded or incorrectly installed.
Ensure there is nothing blocking the air inlets or outlets of the indoor unit and the outdoor unit.
Ensure the condensate drains smoothly out of the drain hose during COOL or DRY operations.
Before a Long Idle Period
Operate the unit in
“FAN only” mode for several hours on a dry day to ensure the inside is completely dry.
After operation stops, shut off the breaker for the air conditioner.
Clean the air filters and reinstall them.
Remove batteries from the remote control.
When a multi outdoor unit is connected, make sure the Heat operation is not used in another room while running the fan operation.
