YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
16
Component Identification
Air outlet
Air outlet
Display
Front panel
Louvers (vertical blades)
These louvers are inside of the air
outlet.
Air inlet
Air filter
Louver (horizontal blade)
Cool mode lamp
Heat mode lamp
Dry mode lamp
Run lamp
LED display
Indoor Unit ON/OFF switch:
Push this switch once to start
operation.
Push once again to stop it.
The operation mode refers to
the following table.
Model
Mode
Temperature setting
Air flow rate
HEAT PUMP
AUTO
26°C (78.8°F)
AUTO
This switch is useful when the remote controller is missing.
Signal receiver:
a. It receives signals from the remote controller.
b. When the unit receives a signal, you will hear a short beep.
c. Settings change the beep.
Air outlet selection switch.
Titanium Apatite Photocatalytic Air-Purifying Filter.
These filters are attached to the inside of the unit.
Before opening the front panel, be sure to stop unit operation and turn the breaker OFF.
Do not touch the metal parts on the inside of the indoor unit, as an injury may occur.
If the power supply cord is damaged, it must be replaced by the manufacturer or an approved equivalent and
be installed by a qualified technician. This will help to prevent or avoid an electrical shock.
The unit must be installed in accordance with national and local wiring codes.
An all-pole disconnection switch, having a contact separation of at least 3mm in all poles, should be
connected in the fixed wiring.
