YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
32
Guide for General Operation
1.
Combination of “+”and “-” buttons: About lock
2.
Press “+” and “-” buttons simultaneously to lock or unlock the keypad. If the remote controller is
locked,
is displayed. In this case, pressing any button caused the
icon to blink three
times.
3. Combinati
on of “MODE “ and “-” buttons switch between Fahrenheit and Celsius. With the unit
OFF, press “MODE” and “-” buttons simultaneously to switch between C and F.
4.
Combination of “ TEMP “ and “CLOCK” buttons : About Energy-saving Function
5.
Press “TEMP” and “CLOCK” simultaneously in COOL mode to start energy-saving function.
6. Nixie tube on the remote controller dis
plays “SE”. Repeat the operation to quit the function. 4)
Combination of “TEMP “ and “CLOCK” buttons: About 46F Heating Function
7.
Press “TEMP” and “CLOCK” simultaneously in HEAT mode to start 46F Heating Function Nixie
tube on the remote controller display
s “ ” and a selected temperature of “46F”.
8. (46F if Fahrenheit is adopted). Repeat the operation to quit the function. 5)
About Back-lighting Function
9. The unit lights for 4s when energizing for the first time, and 3s for later press.
NOTICE
CHANGING BATTERIES AND NOTICES
1) Press slightly along the arrowhead direction to push the back cover open on the remote control.
2) Take out the old batteries. (As show in figure)
3) Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure)
4) Attach the back cover of wireless remote control. (As show in figure)
NOTE:
During operation, point the remote control signal sender at the receiving window on indoor unit.
The distance between signal sender and receiving window should be no more than 8m, and there should be
no obstacles between them.
Signal may be experience interference in rooms where there are fluorescent lamps or wireless telephones.
The remote controller should be kept close to indoor unit during operation.
Replace new batteries of the same model when replacement is required.
When you don’t use remote controller for a long time, please take out the batteries.
If the display on remote controller is fuzzy or there’s no display, please replace batteries.
NOTES:
When changing the batteries, do not use old or different batteries that could cause the remote control to
malfunction.
Use the remote in its receiving range. Remote should be used 36 inches away from a TV set or stereo.
If the wireless remote control cannot operate normally, please take the batteries out, wait 30 seconds and
reinsert them. If the remote still doesn’t operate normally, please replace the batteries.
If the wireless remote control will not be used for an extended period, it is recommended to remove the
batteries. Leaving the batteries in could cause them to leak. This can cause damage to the remote control.
The operation of the remote controller must be performed within its receiving range.
To control the main unit, point the remote controller at the signal receiving window on the main unit to
improve the receiving sensitivity of main unit.
If the remote control does not operate normally, take the batteries out for 30 seconds, and then reinsert
them. If it still does not operate properly, replace the batteries.
