YippieYo CROSSBUGGY, Инструкция по эксплуатации

Страница: 13 / 20

9
Edition: February 2016
Putting on the side bolsters:
1. Feed the side bolster flaps through the four slits between the seat pan
and the tubular frame. Place the upper part of the bolster over the
armrest so that the finger guard element is positioned between the two
upper slits and the side bolster.
2. Pull the rubber cord through the eyelets and connect the upper and
lower eyelets. Begin at the back end of the buggy and pull both cord
ends at the front through the cord stopper. (Fig. 11)
3. With the help of the cord stopper tighten the rubber cord to tauten the
side bolsters. For extra safety you can tie a knot in each of the cord
ends.
Fig. 11
Cord stopper
Slits for the finger-guard element
Removing and putting on the side bolsters
Removing the side bolsters:
1. Untie the knots on both ends of the cord and remove the cord
stoppers.
2. Pull the cord through the eyelets of the side bolsters.
3. Pull the side bolster flaps out of the slits between the seat shell and
the tubular frame.