Yeswelder YWM-200, Руководство оператора

Страница: 22 / 36

- 19 -
Ÿ
Remove the MIG torch consumables.
Ÿ
Remove the liner retaining nut.
Ÿ
Pull out the liner completely.
Ÿ Untie the new liner. Ÿ Feed the liner in short forward move-
ments down the cable assembly all the
way through and out the torch end.
Ÿ
Push the liner firmly into the torch lead
and tighten retaining nut.
Ÿ
Disengage the drive roller.
Ÿ
Use a screwdriver or other sharp object
to push out outlet guide tube through the
Euro connector.
Ÿ Loosen the outlet guide tube screw. Ÿ Remove the outlet guide tube from the
front-end euro connector using long
nose pliers.
Ÿ
Unscrew the inlet guide tube from the
wire feeding mechanism.
Ÿ
Feed the extended graphene liner into
the outlet guide tube hole of the machine
Euro connector.
Ÿ
Feed the extended graphene liner over
the drive roller into the inlet guide tube
part.
Ÿ
Tighten the torch Euro connection to the
Euro connector.
Ÿ Cut the extended liner with a sharp knife.
The remaining part should be about
14ga~12ga away from the wire drive
roller. Ÿ Install the correct sized U Knurled Drive
roller, and with the correct diameter knurl
inside.
Ÿ
Remove the metal tube from the inlet
guide tube.
Ÿ Install a matched contact tip and other
front-end accessories to the torch. It is
ready for welding.