Yeswelder YWM-200, Руководство оператора

Страница: 20 / 36

Set up for Aluminum Welding with Spool Gun
- 17 -
Ÿ
Install optional YesWelder LBT150 spool gun into Euro MIG torch connection socket on the front panel, and tighten it. Connect the
Spool Gun control cable to the receptacle and tighten it.
IMPORTANT: When connecting the torch, be sure to tighten the connection. A loose connection can result in the
connector arcing and damaging the machine and gun connector. This type of damage is not covered under warranty.
Ÿ Plug the 2-pin gun trigger connector into the Spool Gun Trigger Connector Receptacle.
Ÿ
Connect to Wire Drive Polarity (+) Lead to the Positive socket.
Ÿ Connect the Work Clamp into the Negative (-) socket.
Ÿ
Connect the gas line to the regulator and connect to the gas cylinder with 100% Argon shielding Gas.
Ÿ with 100% Argon shielding Gas.
Ÿ
Push the Cover Release clip on the spool gun to unlock the wire housing cover.
Ÿ Place the spool of welding wire on the spool holder, correctly putting the parts back on. (Note: the tensioner part needs to remove
first, and remember to put it back.)
Ÿ Hold and snip the wire. (IMPORTANT: wire can uncoil quickly without an appropriate holding)
Ÿ
Put the wire into the groove of the drive roller, and feed it through the outlet guide tube into the torch. Ensure the wire being used
complies with the size of the roller groove.
Ÿ
Adjust the spool holder’s tension to enable a smooth and stable wire feeding.
Ÿ
Remove the gas nozzle and contact tip from the welding torch.
Ÿ
Pull the trigger to feed the wire until it exits the contact tip holder.
Ÿ
Install a correct-sized contact tip, screw the contact tip into the tip holder of the torch, and tighten it up.
Ÿ
Install the gas nozzle to the torch head and close the wire spool cover.
Ÿ
Turn the power source on and choose the Manual MIG function with the selector button (3).
Ÿ
Press Menu button and select weld spec with Syn off.
Ÿ
Choose the material, Aluminum with the selector button (2).
Ÿ
Set gun selector toggle switch to Spool Gun inside the wire feeding door.
Ÿ
Turn on the gas cylinder valve and set the flow rate to between 20~30 CFH.
Ÿ
Set the welding parameters and begin aluminum welding.