S-Series IP PBX Administrator Guide
12
System Settings
This chapter explains system settings on S-Series. Go to
Settings > System
to check the system
settings.
Network
After successfully logging in the S-Series Web GUI for the first time with the factory IP address, users
could go to
Settings > System > Network
to configure the network for S-Series.
Yeastar S-Series supports two Ethernet modes: Dual and Bridge.
Basic Settings
Please check the basic network settings below.
Table 3-1 Network Basic Settings Description
Basic Settings
Hostname
Set the hostname for the system.
Mode
Select the Ethernet mode. The default mode is Dual.
Bridge:
LAN port interface will be used for uplink connection. WAN
port interface will be used as bridge for PC connection.
Dual: the two Ethernet interfaces will use different IP addresses.
Assign two IP addresses in this mode.
Default Interface
In Dual mode, you need to choose the default interface.
LAN/WAN Settings (DHCP Mode)
If you choose this mode, the system will act as DHCP client to get an available IP address from
your local network.
LAN/WAN Settings (Static IP Address)
IP Address
Enter the IP address (xxx.xxx.xxx.xxx).
Subnet Mask
Enter the subnet mask (xxx.xxx.xxx.xxx). For example, 255.255.255.0
Gateway
Enter the gateway address (xxx.xxx.xxx.xxx).
Preferred DNS Server Enter the IP address of the preferred DNS server (xxx.xxx.xxx.xxx).
Alternate DNS Server
Enter the IP address of the alternative DNS server (xxx.xxx.xxx.xxx).
LAN/WAN Settings (PPPoE)
Username
Enter the PPPoE username.
Password
Enter the PPPoE password.
