Yealink CPE80, Руководство администратора

Страница: 306 / 321

Administrator’s Guide for Yealink VC110 Video Conferencing Endpoint
290
page 261 and H.235 on page 264 .

Ensure that the far site supports the same call protocol as the local site.
Why does the endpoint fail to call the far site via IP address?

Ensure that at least one call protocol is enabled on both sites. For more information, refer
to
Configuring SIP Settings on page 134 and Configuring H.323 Settings on page 138 .

Ensure that the network is connected correctly.

Ensure that the network is configured correctly. For more information, refer to Configuring
LAN Properties on page 56 .

Ping the IP address of the far site. Contact your system administrator if it fails. For more
information, refer to
Using Diagnostic Methods on page 286 .
Why doesn’t the status bar of the display device display IP address?

Check whether the network is available.

Check whether the LAN property is configured correctly. For more information on LAN
property configuration, refer to
Configuring LAN Properties on page 56 .

Check whether the endpoint has enabled the hide IP address feature. For more information
on disabling the hide IP address feature, refer to
Hiding IP Address on page 183 .

Check whether the endpoint has configured firewall and NAT correctly. For more
information on, refer to
Configuring the Endpoint for Use with a Firewall or NAT on page
86 .
Why does the network keep losing packets?

Check whether the network is available and the LED indicator on the left of the Internet
port illuminates green.

Try to use the low speed connection to check whether packets are lost. Deficient
bandwidth is an important reason for packet loss.

Check the configuration of the network speed and duplex mode on the endpoint, switch
and router.
Camera Issues
Why can’t I adjust the camera angle and focus?

You can adjust the camera when the endpoint is idle or during a call. The camera cannot
be adjusted when the endpoint is in the menu screen.

Ensure that the batteries in the remote control are in good working condition, and
installed correctly.

Aim the remote control at the sensor when operating the unit.