YATO YT-82924, Инструкция по эксплуатации

Страница: 16 / 104

16
EN
O R I G I N A L I N S T R U C T I O N S
The red LED will light up, which indicates the charging process.
When charging is complete, the red LED will turn o ff and the green LED will light up to indicate that the battery is fully charged.
Pull the power unit plug out of the mains socket.
Pull the battery out of the charging station by pressing the battery clamp button.
Caution! If the green LED lights up when the charger is connected to the mains, the battery is fully charged. In this case, the
charger will not start the charging process.
Error messages
The tool displays codes of errors that the sensors have detected. Each of the errors has its own code.
E1 – overload protection trip. Switch the tool o ff and on again, if this does not work, the tool has been damaged and must be
handed over to an authorised service centre.
E3 – tool switch protection trip. Switch the tool o ff and on again, if this does not work, the tool has been damaged and must be
handed over to an authorised service centre.
E4 – disc rotary movement blockage which may indicate the overloading or damage to the tool. Switch the tool o ff and on again,
if this does not work, the tool has been damaged and must be handed over to an authorised service centre.
E5 – tool overheating. The tool has been running for too long with too much load. Switch the tool o ff and wait at least 30 minutes
for it to cool down.
E6 – supply voltage too low. Switch o ff the tool, remove the battery and charge it or connect another fully charged one.
E7 – damage to the device. Switch the tool o ff and on again, if this does not work, the tool has been damaged and must be handed
over to an authorised service centre.
E8 – damaged motor. Switch the tool o ff and on again, if this does not work, the tool has been damaged and must be handed over
to an authorised service centre.
E9 – supply voltage too high. The tool must be switched o ff and the battery removed. Make sure that the rated voltage of the
battery complies with that of the tool.
MAINTENANCE AND INSPECTIONS
CAUTION! Remove the battery from the device’s socket before performing adjustment, technical service or maintenance. Having
fi nished working, check the device for damage by visually inspecting the exterior and the body and the battery handle, the func-
tioning of the electric switch, the vents for clogging, the motor brushes for sparking, the noise level of the bearings and the drive
transmission, and how the device starts and runs. During the warranty period, the user is not allowed to install any power tools or
replace any components or parts, as this will void the warranty rights. Any irregularities found during the check or the operation
signal the need for repair to be done at the servicing centre. Having fi nished your work, clean the housing, the vents, all switches,
all handles and guards with compressed air (at 0.3 MPa maximum), a brush or a dry cloth. Do not use any chemicals or cleaners.
Clean the cutter and the handles with a clean dry cloth.
After each use, remove the disc and clean the inside of the disc chamber. The dusty chamber reduces the dust extraction e ffi cien-
cy which impairs the conditions and safety in the workplace. Hold the disc by hand and use a wrench to unscrew the fi xing screw
(VI). Clean the interior of the dust extraction chamber with a paint brush or a brush with a soft bristle and a stream of compressed
air at a pressure of not more than 0.3 MPa. After cleaning the inside of the chamber, install the disc and screw the fastening screw.
The tool has a wrench holder in which it should be stored each time it is not used.