6-2
166006-1CD
166006-1CD
6
Maintenance and Inspection
6.1 Inspection Interval
RM2-755/1255SL
Positioner
6.1 Inspection Interval
Proper inspections and maintenance are important to ensure proper and
safe operations.
Table 6
-
1: Periodic Maintenance for Positioner
NOTICE
The motor and reducer are not recommended for field service. The unit
should be returned for repairs to these components.
Inspection Item
Frequency
Inspection Operation
Physical damage
Daily
Check for physical damage; this indicates a load
collision and is evidence of misuse.
Excessive or unusual noise
Daily
Listen for grinding, excessive or irregular noise.
Contact Customer Support. Refer to
“Customer Support Information” on page 1-6
Main Axis Gear and Pinion Teeth
Weekly
1.
Grease Fittings (IF EQUIPPED)
Grease with Yaskawa P/N 180144-1,
Mobil CM-P, Lithium Complex. Apply grease with
a grease gun thru the grease fitting on the
bottom. Apply three squeezes of grease gun
lever (approximately 4g). In TEACH mode rotate
the Gear/Reducer pinion 180 degrees and apply
grease to the grease fitting that is located on
bottom.
a)
2.
MultiPort Lubricator (IF EQUIPPED)
Inspect and fill the reservoir as required with
Yaskawa P/N 180144-1, Mobil CM-P, Lithium
Complex grease.
Weld Brushes
Weekly
Check for dirt and ensure full contact with
faceplate.
Cleaning
As required
Clean with dry cloth or compressed air.
Positioner Axis Motor Connectors
•
1,000 H
•
6,000 H
•
12,000 H
Check for loose connections. tighten if necessary.
Positioner Main Axis Speed Reducer
6,000 H
Grease with Yaskawa P/N 132412-1,
Molywhite RE00
Positioner Tooling Axis Speed
Reducer
12,000 H
Limit Switch Actuator for Positioner
Axis
•
6,000 H
•
12,000 H
Check for damage and looseness. Tighten and
check the actuator movement.
Tailstock Main Sweep Axis Bearing
Monthly
Grease with Yaskawa P/N 180144-1, Mobil
CM-P, Lithium Complex. Apply grease with a
grease gun thru the two grease fittings on each
side. Apply five squeezes of the grease gun lever
(approximately 2@ 1.25g x 5).
53 of 145
