EN 10
YASKAWA ELECTRIC
TOEP C710617 17B YASKAWA AC Drive GA700 Initial Steps
7
LED Status Ring
The LED Status Ring on the drive cover shows the drive operating status.
A - ALM/ERR
B - Ready
C - RUN
LED
State
Description
A
ALM/ERR
Illuminated
The drive detected a fault.
Flashing
The drive detects:
•
An alarm
•
An
oPE
parameter setting error
•
A fault or error during Auto-Tuning.
Note:
The LED will illuminate to identify a fault if the drive detects a fault and an alarm at the
same time.
OFF
The drive is in regular operation without alarms or faults.
B
Ready
Illuminated
The drive is operating or is prepared for operation.
Flashing
The drive is in
STo [Safe Torque Off]
Mode.
OFF
•
The drive detects a fault.
•
There is no fault and the drive received an operation command, but the drive cannot operate
(such as when in Programming Mode,or when
is flashing).
C
RUN
Illuminated
The drive is in regular operation.
Flashing
•
When the drive is decelerating to stop.
•
The drive received a Run command, but the frequency reference is 0 Hz.
•
When the drive received a DC Injection Braking command.
Flashing Quickly
•
The drive received a Run command from the MFDI terminals and is switching to REMOTE
Mode while the drive is in LOCAL Mode.
•
The drive received a Run command from the MFDI terminals when the drive is not in
Drive Mode.
•
The drive received a Fast Stop command.
•
The safety function shuts off the drive output.
•
The user pushed
on the keypad when the drive is operating in REMOTE Mode.
•
The drive is energized with an active Run command and
b1-17 = 0 [Run Command at
Power Up = Disregard existing RUN command]
.
•
When the drive is set to coast-to-stop with timer (
b1-03 = 3 [Stopping Method Selection =
coast to stop with timer]
), the Run command was activated again during the Run wait time
after once the Run command was disabled.
OFF
The motor is stopped.
*1
Refer to
for the difference between flashing and flashing quickly.
