YARD KING 6331790-43 Series, Инструкция

Страница: 15 / 74

OPERATION
15
1741078
Get to know your snow blower and its controls. Be sure you (or any other operator) have read and understood the Operation
Precautions listed on page 2 of this manual.
Figure 14
Electric Chute
Switch
Auger Drive
Clutch Lever
Traction Drive
Clutch Lever
Speed Shift Lever
Chute Deflector
Auger Housing
Height Adjust Skid
Toolbox
Remote Chute Control
Drift Cutter
Primer Button
Gas Fill
Starter Handle
Throttle Control
Lever
Ignition Key
Choke Lever
Scraper Bar
Shear Pin
Electric
Start Button
Clean-out Tool
Discharge
Chute
ENGINE AND SNOW BLOWER OPERATING CONTROLS
The engine operating controls and their functions are as
follows:
Throttle Control Lever
− Controls the engine speed.
Choke Control
− Use to start a cold engine.
Electric Start Button
− Used to start the engine using the
120 volt electric starter.
Prime Button− Used to inject fuel directly into carburetor
manifold to insure fast starts in cool weather.
Ignition Key− Must be inserted to start engine. Pull out to
stop. Do not turn ignition key.
Starter Handle−
Starts the engine manually.
The snow blower operating controls and their functions
are as follows:
Speed Shifter Lever
− Selects the forward and reverse
speed.
Auger Drive Clutch Lever
− Used to engage and disengage
the auger and impeller. To engage push down, to disengage
release.
Traction Drive Clutch Lever − Used to propel snow blower
forward or reverse. Push down to engage, release to
disengage.
Discharge Chute − Changes the direction the snow is
thrown.
Remote Chute Deflector Lever − Push remote lever
forward to discharge snow high and far. Pull remote lever
back to discharge snow down.
Electric Chute Switch − Changes the direction of snow
throwing through the discharge chute.
Chute Deflector − Changes the height the snow is thrown.
Height Adjust Skid−
Used to adjust ground clearance of
auger housing (see To Adjust Skid Height in the
Adjustment/Repair section of this manual).
Toolbox − Spare shear pins, shear bolt wrenches and
spacers are located in toolbox.
Shear Pin
− Shear pins are designed to break (to protect the
machine) if an object becomes lodged in the auger housing.
Drift Cutters −
Cuts a path through snow higher than the
auger housing.
Clean-Out Tool −
Use the clean-out tool to remove snow and
debirs from the discharge chute and the auger housing.