Yanmar ZT350 series, Руководство по установке

Страница: 63 / 80

REMOTE CONTROLS
ZT350 Installation Manual 5-7
Shift Cable Installation and Adjustment
12/05
© 2007 Yanmar Marine International
2. Locate the center of the remote control and
control cable play (backlash):
(a) Shift the remote control to NEUTRAL.
(b) Push in on the control cable end with
enough pressure to remove play, and mark
position 2 on tube.
(c) Pull out on the control cable end with
enough pressure to remove play and mark
position 3 on tube.
(d) Measure the distance between marks 2 and
3 and mark position 1 half-way between
marks 2 and 3.
Figure 5-7
Figure 5-7
NOTICE: Keep center mark 1 aligned with sleeve
end face when making the following adjustment.
Adjust the Shift Control Cable
1. Temporarily install the shift control cable end
guide into the shift lever and insert the clevis
pin.
2. Adjust the shift control cable barrel so that the
hole in the barrel centers with the vertical
centerline of the stud. Ensure that the backlash
center mark is aligned with the edge of the
control cable end guide.
CAUTION! NEVER
attempt to install or remove the shift control
cable barrel from the stud without first
removing the end guide clevis pin from the
shift lever and removing the cable.
Attempting to bend the shift control cable to
install or remove the barrel will put undue
stress on the cable end guide and shift
lever. Damage to both could occur.
3. Remove the shift control cable end guide from
the shift lever by removing the clevis pin.
Figure 5-8
Figure 5-8
1 – Stud
2 – Control Cable Barrel
3 – Backlash Center
4 – Control Cable End Guide
5 – Clevis Pin
4. Install the shift control cable.
5. Install the washer and cotter pin to secure the
barrel. Spread the ends of the cotter pin.
6. Install the clevis pin.
7. Install the cotter pin into the clevis pin. Spread
the ends of the cotter pin.
Figure 5-9
Figure 5-9
1 – Washers - (on both sides of barrel)
2 – Cotter Pin
3 – Cotter Pin (partially shown)
4 – Clevis Pin
8. Shift the remote control lever into the
FORWARD position.
9. Measure the distance between the shift control
cable barrel center and the shift lever stud
center. This distance should be
155.6 ± 1.5 mm (6-1/8 ± 1/16 in).
0006 3 71
(2)
( 3 )
(1)
0006 3 72
(1)
( 3 )
(4)
(5)
(2)
0006 3 7 3
(1)
(2)
( 3 )
(4)