Yanmar ZT350 series, Руководство по установке

Страница: 44 / 80

INSTALLING ENGINE AND DRIVE UNIT
4-22 ZT350 Installation Manual
Installing the Engine
© 2007 Yanmar Marine International
INSTALLING THE ENGINE
CAUTION! Avoid product damage caused by
improper engine alignment. Improper engine
alignment can be caused by mismatched
flywheel housing mounts and inner transom
plate mounting hardware. Ensure that the
flywheel housing mounts and the inner transom
plate mounting hardware, port and starboard,
are the correct parts and match before
installing the engine.
NOTICE: Use hard rubber washers on the inner
transom plate engine mounts.
1. Attach a sling to the lifting eyes on the engine
and adjust so that the engine is level when
suspended.
2. Lift the engine into position in the boat using an
overhead hoist. WARNING! Only use a hoist
with adequate lifting capacity of the engine.
CAUTION! When lowering the engine into
position, NEVER set the engine on the shift
cable. The shift cable outer casing can be
crushed causing difficult or improper
shifting.
3. Align the rear engine mounts with the inner
transom plate mounts.
4. Set the engine on the front engine mounts and
inner transom plate mounts. Do not relieve the
hoist tension at this time.
NOTICE: Engine attaching hardware must be
installed in the sequence illustrated. Install and
torque rear engine mounting bolts with hardware
as illustrated.
Figure 4-41
Figure 4-42
1 – Steel Washer (obtain locally)
2 – Corrected Engine Mount
3 – Hard Rubber Washer
Figure 4-42
Figure 4-43
1 – Bolt
2 – Spacer
3 – Steel Washer (obtain locally)
4 – Inner Transom Plate Mount
5 – Hard Rubber Washer
6 – Rear Engine Mount
7 – Washer
5. Adjust the front engine mounts until they rest on
the boat stringers.
6. Set the engine on the stringers.
7. Relieve the hoist tension.
8. Disconnect the sling from the engine lifting
eyes.
NOTICE: The finished boat stringer must position
the front engine mount so that a minimum of 6 mm
(1/4 in.) up or down adjustment exists after the
mount is adjusted to contact the stringer. This
allows for future engine alignment or adjustments.
Make proper alterations to the boat stringer
(structure) height to obtain the 6 mm (1/4 in.)
dimension.
(
3
)
(2)
(1)
00060 8 5
00060 8 6
(1)
(6)
(7)
(2)
( 3 )
(5)
(4)