INSTALLING ENGINE AND DRIVE UNIT
4-12
ZT350 Installation Manual
Installing the Transom Assembly
© 2007 Yanmar Marine International
Connecting the Inlet Water Hose
Figure 4-20
Figure 4-20
1 – Gimbal Housing
2 – Speedometer Hose
3 – Water Hose
4 – Trim Sender Limit Switch Wires
WARNING!
Avoid water leaking into the boat.
Damage to U-joint bellows could result from
water entering the boat. Do not damage the
U-joint bellows when removing the section of
the water hose attached between the gimbal
housing and bell housing.
Note: Move the trim sender limit switch wires
and speedometer hose to avoid
damaging them when cutting the inlet
drive shaft water hose. The existing tie
strap and clip can be reused if they are
moved and repositioned after the hose is
cut.
1. Cut completely through the inlet water hose 127
mm (5 in.) in front of the aft end of the hose
where it is fitted into the bell housing. Do not
damage the U-joint bellows.
2. Discard the loose hose piece.
3. Secure the trim sender limit switch wires and
speedometer hose to the remaining section of
water hose using the existing tie strap and clip.
Figure 4-21
Figure 4-21
1 – Water Hose
2 – Speedometer Hose
3 – Clip
4 – Trim Sender Limit Switch Wires
5 – Measurement: 127 mm (5 in.)
(
3
)
(4)
(1)
(2)
0006059
(1)
(5)
(
3
)
(4)
(2)
0006060
Содержание ZT350 series
Страница 1: ...ZT350 series INSTALLATION MANUAL ZT350 Installation Manual P N 0FZTD G00100 STERN DRIVE ...
Страница 6: ...vi ZT350 Installation Manual 2007 Yanmar Marine International This Page Intentionally Left Blank ...
Страница 12: ...SAFETY 1 6 ZT350 Installation Manual 2007 Yanmar Marine International This Page Intentionally Left Blank ...