Yanmar ZT350 series, Руководство по установке

Страница: 18 / 80

GENERAL INFORMATION
2-6 ZT350 Installation Manual
Corrosion Control
© 2007 Yanmar Marine International
Antifouling Paint
NOTICE: Corrosion damage that results from the
improper application of marine paint or antifouling
paint is not covered by the Yanmar limited warranty.
Observe the following precautions when applying
antifouling or marine paint to the transom of the
boat hull.
• NEVER paint the anodes of installed on the
stern-drive.
• NEVER paint the Y-CaPS reference electrode
and / or anode.
• NEVER wash the stern-drive with a high pressure
washer. This could damage the coating on the
reference wire.
• NEVER paint the stern-drive with a material that
contains copper or tin.
• NEVER paint over drain holes, anodes, Y-CaPS
or other items specified by the anode
manufacturer.
Painting the Transom and
Stern-Drive
Corrosion damage that results from improper
application of anti-fouling paint will not be covered
by the warranty.
Anti-fouling paint may be applied to the vessel hull
and the vessel transom.
NOTICE: NEVER paint the anodes or Y-CaPS
electrode. Painting these components will render
them ineffective as galvanic corrosion inhibitors.
NOTICE: Use copper-based paint as anti-fouling
protection for the vessel hull or vessel transom, as
long as it is not prohibited by law in the area where
the vessel will be operated. If using copper- or
tin-based anti-fouling paint, avoid an electrical
interconnection between the Yanmar product,
anodic blocks, or Y-CaPS and the paint by allowing
a minimum of 40 mm (1-1/2 in.) of UNPAINTED
area on the transom of the vessel and around these
items.
Figure 2-1
Figure 2-1
1 – Painted Vessel Transom
2 – Minimum 40 mm (1-1/2 in.) of unpainted area
around transom assembly.
NOTICE: The drive unit and transom assembly can
be painted with a good quality marine paint or an
anti-fouling paint that does not contain copper or
any other material that could conduct electrical
current. NEVER paint drain holes, anodes, Y-CaPS
or items specified by the vessel manufacturer.
NOTICE: NEVER wash the stern-drive with a
power washer because it can damage the coating
on the reference wire and increase corrosion.
(2)
(1)
0006 3 41