Yanmar YDG Series, Руководство по эксплуатации

Страница: 44 / 92

BEFORE YOU OPERATE
30
YDG Operation Manual
Adding Engine Oil
1. Make sure engine is level.
2. Remove oil cap/dipstick (1, Figure 7 ).
3. Add indicated amount of engine oil at either one
of the engine oil filler ports (4, Figure 7 ).
4. Wait one minute and check oil level.
5. Add engine oil as needed until the level is
between the upper (2, Figure 7 ) and lower
(3, Figure 7 ) lines on the oil cap/dipstick .
NOTICE
Never overfill. Overfilling may result in white
exhaust smoke, engine overspeed or internal
damage.
6. Fully reinsert oil cap/dipstick and hand-tighten.
Over-tightening the oil cap/dipstick will damage
it.
Engine Oil Capacity
The following table shows engine oil capacities for
YANMAR YDG generators.
GENERATOR CHECK
WARNING
Always have a licensed electrician connect the
generator to the utility circuit. The generator
must not be connected to other power sources.
Improper installation can cause the generator
to back-feed into the utility power line. This may
electrocute a power company line repair
person. Also, if the generator is powering
electrical circuits, the chance of an electrical
fire exists.
1. Only use grounded extension cords. Be sure to
use an extension cord with the proper wire
gauge size. See the following table.
2. If electrical separation cannot be adopted for
indirect contact protection (see page 3),
properly ground the unit:
• Attach a #10 stranded-copper ground wire to
the ground lug.
• Drive a grounding point into the ground. The
grounding point can be a stake, grounding rod
or pipe. The grounding point should be copper
or brass.
CAUTION
Never use metal pipe that carries combustible
materials or gases to ground the generator.
Always ground the generator. Connect a
length of heavy wire between the generator
ground terminal and an external ground.
Engine/generator model
Dipstick
upper limit/lower limit
Engine L70V(N)
generator YDG3700V(N)
1.11/0.69 qt
(1.05/0.65 L)
Engine L100V(N)
generator YDG5500V(N)
1.7/1.06 qt
(1.6/1.0 L)
Recommended minimum wire gauges
(AWG) for extension cords
Ampere
load
AWG for length of cord
ft (m)
50 (15) 100 (30) 150 (46)
2 18 18 18
3 18 18 18
4 16 16 16
5 16 16 16
6 16 16 14
8 16 14 12
10 16 14 12
12 14 14 12
14 14 12 10
16 12 12 10
20 10 10 8