Yamaha TT-R125EY, Руководство по обслуживанию

Страница: 247 / 258

6-8
ELEC
– +
INSPECTION STEPS
If the starter motor will not operate, use the following inspection steps.
• Remove the following parts before inspection.
1) Seat
2) Rear fender
3) Fuel tank
• Use 12 V battery in this inspection.
• Use the following special tools in this inspection:
*1 marked: Refer to “FUSE INSPECTION” section in the CHAPTER 3.
*2 marked: Refer to “BATTERY INSPECTION AND CHARGING” section in the CHAPTER 3.
*3 marked: Refer to “MAIN SWITCH INSPECTION” section.
TIP
Pocket tester:
YU-3112-C/90890-03112
ELECTRIC STARTING SYSTEM
*1 Check fuse
*2 Check battery
No good
Replace fuse and
check wire harness.
Recharge or replace.
Repair or replace.
OK
No good
Replace.
Repair or replace.
Replace.
Replace.
Replace.
No good
No good
OK
OK
OK
OK
OK
Check each coupler and
wire connection.
*3 Check main switch.
Check starter motor
operation.
Check starter relay.
Check starting circuit
cut-off relay.
OK
Check neutral switch.
OK
Check clutch switch.
OK
Check start switch.
Replace.
Replace.
No good
No good
No good
No good
No good
No good