Yamaha TMAX XP530E-A 2017, Руководство по обслуживанию

Страница: 504 / 676

FUEL INJECTION SYSTEM
8-113
Fault code No. P2195
TIP
If fault code numbers “P0657”, “P2195” and “P0030”, two or more numbers are indicated, take the ac-
tions specified for fault code number “P0657”, “P0030” and “P2195” in the order.
Fault code No. P2195
Item O
2
sensor: open circuit detected.
Fail-safe system
Able to start engine
Able to drive vehicle
Diagnostic code No. —
Tool display —
Procedure —
Item
Probable cause of malfunc-
tion and check
Maintenance job
Confirmation of service com-
pletion
1 Installed condition of O
2
sensor. Check for looseness or pinch-
ing.
Improperly installed sensor

Reinstall or replace the sensor.
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”

Go
to item 8 and finish the service.
Condition is “Detected”

Go to
item 2.
Also, delete this fault code,
which has a condition of
“Detected”.
2 Connection of O
2
sensor cou-
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
Improperly connected

Con-
nect the coupler securely or
replace the wire harness.
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”

Go
to item 8 and finish the service.
Condition is “Detected”

Go to
item 3.
Also, delete this fault code,
which has a condition of
“Detected”.
3 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
Improperly connected

Con-
nect the coupler securely or
replace the wire harness.
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is “Recovered”

Go
to item 8 and finish the service.
Condition is “Detected”

Go to
item 4.
Also, delete this fault code,
which has a condition of
“Detected”.