Yamaha MTN1000 2016, Руководство по обслуживанию, Страница: 97 / 658

CABLE ROUTING
2-52
1. Headlight stay
2. Front brake master cylinder
3. Throttle cable
4. Handlebar switch (right)
5. Handlebar
6. Throttle cable (decelerator cable)
7. Throttle cable (accelerator cable)
8. Clutch lever holder
9. Handlebar switch (left)
10.Main switch
11.Front brake hose
12.Clamp
13.Guide
14.Handlebar switch lead (right)
15.Front brake light switch lead
16.Throttle cable housing
17.Plastic locking tie
18.Clutch switch lead
19.Handlebar switch lead (left)
20.Horn lead
21.Main switch lead/Immobilizer unit lead
A. When installing the rubber cover, silicone
water or soapy water may be applied to the
inside of the rubber cover.
B. Align the paint mark with the lower end of the
clamp to install the throttle cable.
C. Insert the projection on the clamp into the
hole in the frame.
D. Detailed drawing of the around the front
brake master cylinder
E. Center of the metal fitting for the front brake
hose.
F. Install the brake hose so that the projection
on the master cylinder contacts stopper.
G. Inner side of the vehicle
H. Cut off the excess end of the clamp to 3 mm
(0.12 in) or less.
I. Fasten the positioning tape ends (component
side) of the front brake light switch lead and
handlebar switch lead (right) with the clamp.
Fasten the leads at the positions as shown in
the illustration. Install the clamp securely to
the guide. Cut off the excess end of the
clamp. Point the end of the clamp as shown
in the illustration.
J. Route the main switch lead and immobilizer
unit lead.
K. Fasten the main switch lead and immobilizer
unit lead at the blue tape with the plastic lock-
ing tie.
L. Fasten the positioning tape ends (component
side, black tape) of the clutch switch lead and
handlebar switch lead (left) with the clamp.
Fasten the leads at the positions as shown in
the illustration. Install the clamp securely to
the guide. Cut off the excess end of the
clamp. Point the end of the clamp as shown
in the illustration.
M. Do not fasten the horn lead with the clamp.
There is no positioning tape (black) on the
horn lead.
N. Front of vehicle
O. Bottom of vehicle
P. Fasten the positioning tape ends (component
side) of the clutch switch lead and handlebar
switch lead (left) with the clamp. Fasten the
leads at the positions as shown in the illustra-
tion. Install the clamp securely to the head-
light stay. Cut off the excess end of the clamp.
Point the end of the clamp as shown in the
illustration.
Q. Cut off the excess end of the plastic locking
tie to 5 mm (0.2 in) or less.
R. Cut off the excess end of the plastic locking
tie. The end of the plastic locking tie may be
pointing in any direction.