4. Screens
MMP1 Operation Manual
23
4-1-7. Patch screen
This screen is used to assign input sources and outputs to channels within the MMP1 Editor and I/O connectors.
The Patch screen is split into the “Input Patch” tab and the “Output Patch” tab. Click these tabs to switch between the two.
NOTE
You can use this screen when logged in as an “Administrator” or “Advanced User.”
4-1-7a. Input Patch
Refer to the table on page 25 for more information about input sources that can be assigned.
NOTE
While holding down the right mouse button (Windows) or the <control> key (Mac) on the Source fields, drag up or down on the fields to
select several input sources at the same time.
Monitor Matrix In
• For selecting the input source to be routed on the Monitor Matrix screen.
• Up to 32 channels are available. However, only channels 1-16 will be enabled when the MMP1’s sample rate
being used is higher than 96 kHz. You can change the sample rate in the “MISC” tab of the “Scene” tab on the
Settings screen.
• You can select the format for Monitor Sources 1-8 and Cue Sources 1-8 from the “Monitor Matrix” tab of the
“Scene” tab on the Settings screen.
Channel Strip In
• For selecting the desired input source for operation using the channel strip on the Main screen.
• Channel strips are loaded in two sets, A and B. Use the “Selected Channel” tab on the Main screen to switch
between the two.
Speaker Matrix In
• For selecting the input source to be routed on the Speaker Matrix screen.
• Up to 32 channels are available. However, only channels 1-16 will be enabled when the MMP1’s sample rate
being used is higher than 96 kHz. You can change the sample rate in the “MISC” tab of the “Scene” tab on the
Settings screen.
• You can set the input source Type in the “Speaker Matrix” tab of the “Scene” tab on the Settings screen.
Direct Speaker Send
For selecting input sources to send to speakers without going through the speaker matrix.
Talkback Mic In
For selecting a Talkback mic input source.
